LCD inflation pump solution

Introduction to the functions of the inflation pump scheme
Type: LCD inflation pump solution (customizable)
Measurement range: 0~175PSI (MPa)
Accuracy level: 1.5PSI
Connection type: spiral/insertion type
Environmental temperature: -20~70 ℃
Adopting highly integrated design, LCD/LED digital display;
Adopting intelligent pressure sensing for startup, improving reliability and lifespan;
Intelligent fully automatic control and safety protection functions;
Fault alarm and automatic power-off protection;
Three pressure units can be switched freely: PSI, BAR, KPA;
High measurement and control accuracy, less affected by environmental temperature.
Performance parameters of inflation pump scheme
Measurement pressure range: 0-12Bar (or 0-175Psi);
Measurement error: ≤± 10kPa (or 1.5Psi);
Working (compensation) temperature: -20~70 ℃;
Display resolution: 0.5Psi;
Working voltage: 220VAC/50HZ (can also be customized to 110VAC/60Hz);
Control accuracy: ± 10kPa (or 1.5PSI).
Inflator pump operation
Power on, the LCD screen displays the pressure of the air storage tank, and the air compressor motor enters automatic control mode;
Press the "Unit" key to freely switch between Psi, Bar, and kPa units;
When the pressure of the air compressor does not reach the set lower limit pressure value, the motor starts and compressed gas enters the gas storage tank; When the pressure of the air compressor exceeds the upper limit set value, power off and shut down; When the pressure of the gas tank drops below the lower limit set pressure value, a new round of control state is entered.